CAUTION:
DO NOT smoke around or expose supply tank(s) to open flame or sparks.
Always use the striker provided. Never use a match or lighter to ignite torch. Use of device other than the striker may cause personal injury.
DO NOT place hand or any body part in the path of the flame while lighting or operating torch. This can result in personal injury.
Shut-Off Instructions:
1)Close torch adjusting valve. 2)Close supply tank
3)Open the
CAUTION:
DO NOT smoke around or expose supply tank(s) to open flames or sparks.
Torch end of handle assembly will increase in temperature immediately after shutting off.
Maintenance:
Prior to each use:
1)Visually inspect all components of the device for damage and or wear. If the hose shows excessive abrasion wear, or the hose is cut, it must be replaced prior to operation. If damage is found, contact Mr. Heater for the proper replacement parts.
2)Visually inspect LP gas tank(s) for dents, damage to collar, damage to
3)Perform a leak test according to the leak test procedure described on page 5. 4)Ignite torch according to the lighting instructions described on page 5. Check
operation of the adjusting valve and the other components prior to proceeding.
Periodically:
1)Remove any debris or combustible material from the torch. The torch must be kept clear and free from combustible materials.
2)The surface of the device should be cleaned with soap and water. Do not use
Disconnecting the Supply Tank:
1)Make sure supply tank valve is shut off.
2)Open torch adjusting valve briefly to release any residual gas left in the hose. Close adjusting valve when complete.
3)Disconnect the P.O.L. nut/nipple located at the end of the hose assembly from the supply tank(s).
4)Replace the protective plastic cap and plug to the hose end and supply tank(s) respectively.
Mr. Heater Propane Torch 6 Operating Instructions and Owner’s Manual