Mr. Heater #MH500PT operating instructions If you smell gas Shut off gas to the device

Page 2

FOR YOUR SAFETY!

Read and understand instructions before use! Retain this information for future reference.

If you smell gas:

-Shut off gas to the device.

-DO NOT try to light appliance.

-Extinguish any open flame.

-Check the device for leaks using soapy water.

-DO NOT attempt to relight the device until all leaks are repaired and there is no

gas smell.

DO NOT use this device in areas where gasoline or other liquids having flammable vapors are stored or used.

CAUTION:

This device is intended for outdoor use only. NEVER direct torch flame toward hose or gas tank. DO NOT leave torch unattended while in operation.

DO NOT stand or prop the torch on the burner end while in operation. Always use the striker provided. Never use a match or lighter to ignite torch.

DO NOT apply heat or flame to tank to check for leaks or to increase gas pressure. DO NOT lift tank by the valve.

When not in use the gas should be turned off at the LP gas tank(s). CAUTION – In daylight, torch flame is barely visible.

DO NOT place hand or body part in the path of the flame while lighting or operating torch.

This device is designed for vapor withdrawal from an LP gas tank(s) ONLY.

NOTE:

Place tank on level surface in an upright position.

Do not invert or lay tank on its side.

Gloves should be worn at all times when operating this device. Long sleeves, long pants, and boots are recommended.

Have an ABC type fire extinguisher readily accessible to the job site.

THE STATE OF CALIFORNIA REQUIRES THE FOLLOWING WARNING:

WARNING:

Combustion by-products produced when using this product contain carbon monoxide, a chemical known to the State of California to cause cancer and birth defects (or other reproductive harm).

Mr. Heater Propane Torch 2 Operating Instructions and Owner’s Manual

Image 2
Contents Propane Torch If you smell gas Shut off gas to the device State of California Requires the Following WarningFMH500PT-Parts List DescriptionModel Operating Temperature Range Inlet PressureAssembly Instructions BTULeak Test Lighting InstructionsShut-Off Instructions MaintenanceDisconnecting the Supply Tank Prior to each useSafety Information StorageFor Information Regarding Service Limited Warranty