Installing a Remote Control
Device
Wiring
For a
For a
Heater Settings
1. | Make sure the heater is disabled on the remote |
|
| control device. Then, push the SET key until POL | Fig. 8: Heater Wiring Block |
| is displayed. Push the DOWN arrow key until OFF | |
| is displayed. Wait until a temperature is displayed |
|
| before beginning the next step. |
|
2. | Push the SET key until SPA is displayed, then |
|
| push the UP arrow to 104°F (40°C). Wait until a |
|
| temperature is displayed before beginning the |
|
| next step. |
|
3. | Push the SET key until P_S is displayed, then |
|
| push the DOWN arrow until POL is displayed. |
|
| Wait until a temperature is displayed before begin- |
|
| ning the next step. |
|
4. | Finally, enable the heater on the remote control |
|
| device. When there is a call for heat, the heater |
|
| display will show SPA. When the heater is dis- |
|
| abled, the display will show POL. |
|
19