Figure 4. Attaching the dust chute.
3.Position the dust chute base between the dust chute sides (flanges up), carefully aligning the screw holes in the base and the sides. See Figure 4 and 5. The flanges should be inside the chute.
NOTICE
Make sure the slots in the motor support are toward the top of the stand.
Figure 5. Attaching the dust chute base.
4.Attach the top of the stand to the sides and dust chute. Note that the flanges for the top are inside the stand (the flanges for the dust chute opening should be outside the dust chute, however) and that the opening for the drive belt is at the rear of the stand. See Figure 6.
-12-
Figure 6. Attaching the top of the stand.
5.Turn the stand upside down to mount the motor to the underside of the dust chute. Mount the motor on the chute using the four 5⁄16" - 18 x 3⁄4" hex head bolts, flat washers and nuts provided. Be sure to position the motor pulley to the rear (open end) of the stand as shown in Figure 7. Leave the motor mount bolts finger-tight for now.
Figure 7. Attaching the motor.
G1182 6" Series Jointers