6.The power switch is already installed on the right hand panel of the stand. To complete the wiring, it is first necessary to remove the switch assembly from the stand. Remove the two Phillips® head screws holding the metal mounting plate to the stand. The entire switch can then be pulled out of the stand.
7.Turn the stand upright and securely tighten all fasteners on the stand and dust chute.
Stand (G1182Z, ZX & ZHW)
The stand for the
Jointer to Stand
This step will require at least two people. To mount the jointer to the stand:
1.Lift the main unit onto the stand, making sure to position the cutterhead pulley over the slot in the top of the stand.
2.Carefully align the mounting holes in the stand with the threaded holes in the base of the jointer. Secure the jointer to the stand using the three 3⁄8" - 16 x 3⁄4" hex bolts and 3⁄8" flat washers provided. Be sure not to over- tighten
The jointer main unit is very heavy – you will need assistance when lifting it onto the stand. Serious personal injury may occur if safe mov- ing methods are not fol- lowed.
G1182 6" Series Jointers |