
MVC-64H/HW — INITIAL START-UP
| Caution - Read Manual |
| The CLOSED position of the | |
| NOTE | choke lever enriches the fuel | ||
|
| |||
DO NOT attempt to operate the plate compactor | mixture for starting a COLD | |||
| ||||
| engine. The OPEN position | |||
until the Safety, General Information and |
| |||
| provides the correct fuel mixture | |||
Inspection sections of this manual have been |
| |||
| for normal operation after | |||
read and thoroughly understood. |
| |||
| starting, and for restarting a | |||
|
|
|
1. Place the fuel valve lever (Figure 11) in the "ON" position.
warm engine.
Figure 11. Fuel Valve Lever
2.Place the Engine ON/OFF switch (Figure 12) in the "ON" position.
Figure 12. Engine ON/Off Switch
3. Place the Choke Lever(Figure 13) in the "OPEN" position.
Figure 13. Choke Lever
4.Place the throttle lever (Figure 14) halfway between fast and slow.
Figure 14. Throttle Lever
5.Grasp the starter grip (Figure 15) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingthecompressionpoint.Rewindtheropealittlefrom that point and pull out sharply.
Caution - Starter Rope
DO NOT pull the starter rope all the way to the end.
DO NOT release the starter rope after pulling. Allow it to rewind as soon as possible.
Figure 15. Starter Grip
PAGE 18 —