MVC-64E/EW— COMPONENTS (ENGINE)
Figure 4. Engine Controls and Components
INITIAL SERVICING
The engine (Figure 4) must be checked for proper lubrication and filledwithfuelpriortooperation. Refertothe ROBIN engine service manualforinstructions anddetailsforproperoperationandservicing.
1. Muffler – Used to reduce noise and emissions.
WARNING
Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER
operate the engine with the muffler removed.
2. Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove
3. Fuel Tank – Holds unleaded gasoline. For additional information refer to ROBIN engine owner's manual.
4. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.
DANGER
5. | Throttle Lever – Used to adjust engine RPM speed (lever |
| advanced forward SLOW, lever back toward operator |
| FAST). |
6. | Recoil Starter (pull rope) – |
| the starter grip until resistance is felt, then pull briskly and |
| smoothly. |
7. | Choke Lever – Used in the starting of a cold engine, or in |
| cold weather conditions. The choke enriches the fuel |
| mixture. |
8. | Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop |
| the flow of fuel. |
9. | Spark Plug – Provides spark to the ignition system. Set |
| spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean |
| spark plug once a week. |
10. Engine ON/OFF Switch – ON position permits engine starting, OFF position stops engine operations.
11. Oil Drain Plug – Remove this plug to drain engine oil from the crankcase.
12. Oil Dipstick/ Filler Cap– Remove the filler cap dipstick when checking the engine oil level. Add engine oil through this filler port. See Table 5 for recommended type engine oil.
Adding fuel to the tank should be done only when |
| Operating the engine without an air |
the engine is stopped and has had an opportunity to | NOTE | filter, with a damaged air filter, or a |
cool down. In the event of a fuel spill, DO NOT attempt to start the |
| filter in need of replacement will |
engine until the fuel residue has been completely wiped up, and the |
| allow dirt to enter the engine, |
area surrounding the engine is dry. |
| causing rapid engine wear. |