Porter-Cable 310 instruction manual Using a Laminate Trimmer, Edge Guide KIT

USING A LAMINATE TRIMMER

1.Material to be trimmed must overhang the base material by a least 1/8".

2. Always wear ansi Z87.1 safety glasses while operating a laminate trimmer.

3. DISCONNECT TOOL FROM POWER SOURCE.

4.Firmly grasp motor housing being sure switch is in the “OFF” position.

5.Verify bit is clear of foreign objects and cord will not “hang up” on any obstructions.

6.Be sure workpiece is firmly held in place. Use clamps where necessary to secure workpiece.

7.Plug in power supply cord. Be alert to resist starting torque of motor. Turn motor “ON”.

8.Allow motor to reach “full speed”. Place base of trimmer on surface to be trimmed and feed into work until bit pilot contacts base materials. When guiding on a previously laminated surface, always wax or lubricate the area that the trimmer will guide against.

9.Feed from left to right with smooth steady motion.

10.At completion of trimming operation, turn switch “OFF”. Allow motor to come to a complete stop before laying trimmer down.

A B C D E F G

Fig. 2

73100 EDGE GUIDE KIT

The Model 73100 Edge Guide Kit is available (as an accessory), for use with the Model 310 trimmer. The 73100 is designed for use with non-piloted bits, on curved or straight applications. Non-piloted bits can produce a 90° straight cut, a 10° bevel cut, or a 22° bevel cut. The kit contains the parts shown in Fig. 2. Install the 73100 guide as follows:

A – Base and roller guide - for use with non-piloted bits B – Edge guide – for flush trimming

C – Edge guide – for bevel trimming

D – Straight edge guide – for straight trimming E – Guide setting gauge

F – Mounting screws G – Wrench

11