Porter-Cable 310 Troubleshooting, Flush Trimming, Bevel Trimming, Using Straight Edge Guide

Page 13

FLUSH TRIMMING

1. DISCONNECT TOOL FROM POWER SOURCE.

2.Attach base and guide to trimmer as outlined under ASSEMBLING AND ADJUSTING BASE AND ROLLER.

3.Remove roller guide and replace with flush trimming guide (B) Fig. 2. This guide may be identified by the molded on letter “F”. The stud on the end of this guide must face toward the trimmer base.

4.Install guide setting gauge (E) Fig. 2, into trimmer collet (see TO INSTALL BIT). Install trimmer motor to base. Adjust guide so that hole in end of gauge may be positioned over the guide stud.

5.Remove guide setting gauge from trimmer and install flush trimming bit.

6.Adjust depth of cut so that the straight portion of the bit extends below the trimmer base at least the thickness of the material to be trimmed.

7.Make a trial cut on scrap material. Readjust if necessary.

BEVEL TRIMMING

1.Follow Steps 1 through 5 under FLUSH TRIMMING, except install bevel trimming guide (C) Fig. 2. This guide is identified by the letter “B” molded onto it.

2.Adjust depth of cut so that only the bevel portion of the bit extends below trimmer base at least the thickness of the material to be trimmed.

3.Make a trial cut on scrap material to check alignment. Readjust if necessary.

USING STRAIGHT EDGE GUIDE

The straight edge guide (D) Fig. 2, maybe used with either bit for trimming straight edges.

Assemble it to the guide base and adjust similar to the other guides.

TROUBLESHOOTING

For assistance with your tool, visit our website at www.porter-cable.com for a list of service centers or call the Porter-Cable help line at 1-800-487-8665.

13

Image 13
Contents Laminate Trimmer Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules General Safety Rules Additional Specific Safety Rules Symbol Definition Extension Cord Selection MotorAssembly Operation Carton ContentsFunctional Description ForewordAdjusting BIT Exposure To Install BITTo Remove the BIT Edge Guide KIT Using a Laminate TrimmerAssembling and Adjusting Base and Roller Using Straight Edge Guide TroubleshootingFlush Trimming Bevel TrimmingKeep Tool Clean MaintenanceFailure to Start LubricationAccessories ServiceReplacement Parts Service and Repairs PORTER-CABLE Limited ONE Year Warranty WarrantyCanadian PORTER-CABLE Delta Service Centers