Instructions
Window Installation Instructions.
Operating Instructions Safety
Install the Supports
9 | A | Line up the |
the left and right marks on the stool. Make |
sure that the support rail is against the back of the stool and drill two 1/8″ pilot holes into the stool through the holes in the head of the support rail. Attach the supports to the stool using two Type B screws in each support.
Supports
BAdjust the leveling bolts against the sill so that the supports have a slight tilt to the outside. Use a level; about 1/2 bubble will be the correct slant to the outside.
1/2 bubble
Leveling bolt
NOTE: Use a steel washer between the leveling bolts and the sill if the sill is weak.
Instructions
Sill
Type B | Stool |
| |
screws |
|
Support Troubleshooting Tips Installation
Install the Case in the Window
10 | A | Carefully slide the case into the window until | |
the bottom mounting rail drops into the | |||
| |||
|
| channels in the supports. Center the case and | |
|
| lower the window behind the top mounting | |
|
| rail. The case should be slightly tilted to the | |
|
| outside. Use a level; about a 1/2 bubble will | |
|
| be the correct case slant to the outside. | |
|
| Attach the bottom of the case to the support | |
| B | ||
|
| rail with a Type A screw, 1 on each side. | |
|
|
CExtend the left and right accordion panels to the vertical window sashes, drill 1/8″ pilot holes, and attach the top corners with 2 Type B
screws. Use an accordion panel clamp on each lower corner to trap the panels. Drill 1/8″ pilot holes and attach the panel clamps with Type B screws.
Top mounting rail
Type B
screwType B screw
Panel clamp and
Type B screw
Consumer
Panel clamp and
Type B screw
NOTE: Seal any openings around the case or accordion panels with sealer or foam gaskets.
14