WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN
Trouble Shooting
TROUBLE | PROBABLE CAUSE |
| SUGGESTED REMEDY |
|
|
|
|
1. Fan will not start. | 1. Fuse or circuit breaker blown. | 1. | Check main and branch circuit fuses or circuit breakers. |
| 2. Loose power line connections to the fan, or loose | 2. | Check line power connections to fan and switch wire |
| switch wire connections in the switch housing. |
| connections in the switch housing. |
|
|
| WARNING: Make sure main power is turned off. |
| 3. Fan/Light Wall Control is OFF. | 3. | Turn ON Fan/Light Wall Control. |
| 4. Code switches in wall control/receiver are | 4. | Check that both code switches are set in the same |
| not set in the same position. |
| positions. |
|
|
|
|
2. Fan sounds | 1. Blades not attached to fan. | 1. | Attach blades to fan before operating. |
noisy. | 2. Screws securing fan blades to motor | 2. | Check to make sure the screws which attach the fan blades |
| |||
| are loose. |
| to the motor are tight. |
| 3. Wire connectors inside switch housing rattling. | 3. | Check to make sure wire connectors in switch housing are |
|
|
| not rattling against each other or against the interior wall of |
|
|
| the switch housing. |
|
|
| WARNING: Make sure main power is turned off. |
| 4. Loose screws in motor housing. | 4. | Check to make sure all screws in motor housing are snug |
|
|
| (not |
|
|
|
|
3. Fan wobbles | 1. Setscrew in motor coupling is not tightened | 1. | Raise coupling cover and tighten setscrew securely. |
excessively. | securely. |
|
|
| 2. Setscrews in the hanger ball/downrod | 2. | Tighten the setscrews in the hanger ball/downrod assembly. |
| assembly are loose. |
|
|
| 3. Screws securing fan blade to | 3. | Check to be sure screws which attach the fan blade |
| motor are loose. |
| to the motor are tight. |
| 4. Fan blades are not seated properly. | 4. | Check to be sure the fan blade flanges seat firmly and |
|
|
| uniformly to the surface of the motor. If blades are seated |
|
|
| incorrectly, loosen the blade screws and retighten. |
| 5. Hanger bracket and/or ceiling outlet box is | 5. | Tighten the hanger bracket screws to the outlet box, and/or |
| not securely fastened |
| secure outlet box. |
| 6. Fan blades out of balance. | 6. | Interchanging an adjacent |
|
|
| redistribute the weight and result in smoother operation. |
|
|
| Or use supplied balancing kit to balance blades. |
|
|
|
|
14
