Emerson CF980MAB 00, CF980MBX 00 warranty Halogen Bulb and Glass Installation

Halogen Bulb and Glass Installation

1.Do not touch the new 50-watt (maximum) MR-16, GU-10 bulb with your bare fingers; using a cloth or soft gloves to hold the bulb, gently push it into the socket and twist to lock the lamp into the socket (Figure 18). If there is any doubt that the bulb may have been contaminated by your touch, you should clean the bulb before its first use. Take a clean cloth dipped in a small amount of rubbing/isopropyl alcohol and gently brush off the bulb surface. If the lamp is hot, wait 30 minutes before cleaning.

CAUTION: To reduce the risk of electric shock, burns or other injury, disconnect the electric sup- ply circuit to the fan before attempting to install or replace the halogen bulb.

CAUTION: To not touch halogen bulbs with bare hands. Fingerprints may result in shorter bulb life. Remove fingerprints with alcohol.

2.Place the glass onto the light kit assembly aligning the three flat areas on the top flange of the glass with the three pins on the inside of the assembly (Figure 19). Then turn the glass clockwise until it stops turning.

LIGHT KIT

ASSEMBLY

FLAT AREA (3)

GLASS

Figure 19

3.Your ceiling fan is now installed and wire to be controlled by your remote control system.

LIGHT KIT SOCKET

50-WATT MR-16, GU-10 HALOGEN BULB

Figure 18

10