Emerson CF980MBX 00, CF980MAB 00 warranty Unpacking Instructions

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly	Installed Wire Length	Wire Size A.W.G.
One Phillips head screwdriver	Up to 50 ft.	14
	50-100 ft.	12
One stepladder

MATERIALS

Wiring, outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following sizes:

WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 8). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

a.

b. n.

1.Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a. One ceiling cover

c.

d.

h.

i.

j.

b.	One hanger bracket
c.	One hanger ball/downrod assembly
d.	One coupling cover
e.	Fan motor and housing assembly
f.	Four blade flanges
g.	Four fan blades
h.	One light kit assembly
i.	Three 50-watt, MR-16, GU-10 halogen bulbs
j.	One light kit glass
k.	One SW114 wall control/3 wall control covers
l.	One loose parts bag containing:
	1.	Thirteen #10-24 x 1/4” oval head blade screws
	2.	Nine 1/4-20 x 1/2” oval head flange screws
	3.	Two 1-1/4” threaded studs
	4.	Two knurled knobs
	5.	Two lockwashers

7. One hairpin clip

8. One clevis pin

9. Four #10-24 x 1” lower housing screws

10. Four #10-24 x 5/16” pan head screws m. One SW105 receiver

n. One lower housing

3

e.

m.

LIGHT

RERVEV

f. k.

l.

g.