CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the bottom of the light kit assembly and fan motor.
5.Install the three
LIGHT KIT
ASSEMBLY
MOTOR
COUPLING
SETSCREW (2)
CLEVIS PIN | HAIRPIN | |
CLIP | ||
|
CLEVIS PIN
DOWNROD
HAIRPIN CLIP
MOTOR
COUPLING
SETSCREW (2)
LOWER
HOUSING
Figure 4
6.Carefully turn the partially assembled fan motor
housing onto the styrofoam section. The styrofoam section will hold the assembly while you perform the following steps.
7.Remove the hanger ball from the downrod by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 5). Remove the pin from the downrod, then remove
the hanger ball. Retain the pin and hanger ball for reinstallation in Step 15.
PIN
HANGER
BALL
DOWNROD | SETSCREW |
|
Figure 5
8.Separate, untwist and unkink the three motor leads. Route the motor leads through the downrod and seat the downrod in the motor coupling (Figure 6).
9.Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 6). (Pin and clip are supplied in loose parts bag.) The cle- vis pin must go through the holes in the motor cou- pling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull the downrod to make sure the clevis pin is properly installed.
Figure 6
WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew is securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 2) could result in the fan falling.
10.Install the two setscrew (supplied) in the motor coupling (Figure 6). While pulling up on the downrod, tighten the setscrews using the setscrew wrench (supplied).
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
11.Mount the blade flanges to fan blades using three
NOTE: Be sure to position the flange onto the blade with the ribs side up.
WARNING
To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
FLANGE
BLADE
Figure 7
NOTE: Take care not to scratch fan housing when installing blades.
5
