SW105 | TO | |
RECEIVER | 110V | |
BLACK | SUPPLY | |
SUPPLY |
| |
WHITE RECEIVER WIRE | WHITE SUPPLY WIRE | |
BLACK RECEIVER WIRE | ||
BLACK/WHITE RECEIVER | BLUE RECEIVER WIRE | |
WHITE FAN WIRE | ||
BLUE FAN WIRE | ||
| ||
BLACK FAN WIRE | YELLOW RECEIVER | |
| WIRE | |
| DO NOT USE | |
DOWNROD |
|
Figure 15
WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
4.Carefully turn the wires upward and insert them up through the open side of the hanger bracket and into the outlet box. Push the green and white wires into one side of the outlet box; push the black, blue and yellow wires into the other side of the outlet box.
OUTLET BOX
HANGER
BRACKET
RECEIVER
CEILING
COVER
Figure 16
7.Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 17.) Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan switch.
CEILING | ||
THREADED | ||
COVER | ||
STUD | ||
| ||
| LOCKWASHER |
KNURLED KNOB
Figure 17
WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
5.Screw the two
6.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 17).
9
