Safety advice relating specifically to this device
JChildren or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Children must never be allowed to play with the device.
ATTEntIOn! To avoid the danger of injury, burning and dangers to your health:
JIf danger arises, pull the mains plug immediate- ly out of the mains socket.
Danger of Personal Injury! Never use the appliance as a hair dryer.
J Do not direct the heat flow at persons | ||||
| or animals. | |||
J Do not look directly into the opening of the heat | ||||
J | nozzle | 3 | . | |
|
|
| Danger of burns! Do not | |
|
|
| ||
|
|
|
| touch the hot nozzle. Wear protec- |
J |
|
|
| tive gloves. |
|
|
| Wear protective glasses. | |
|
|
| ||
J |
|
|
| Danger oF Fire and ExpLO- |
|
|
| ||
|
|
| ||
|
|
|
| sIOn! The appliance develops |
|
|
|
| very high temperatures. |
|
|
|
| |
|
|
|
| If the device is not used carefully, |
|
|
|
| it can give rise to increased risk of |
General safety advice / Operation
using the device, always pull the mains plug out of the mains socket.
JDo not direct the device at the same spot for too long a period.
JMaintain a distance between the jet outlet nozzle and the workpiece or the surface being heated. An air blockage could lead to over- heating of the appliance.
JPay heed to the direct working area and also to its surroundings. The heat produced could reach to inflammable articles located out of the visible area.
JAlways keep the device clean, dry and free of oil or grease.
JNever use the device for a purpose for which it was not intended.
QOperation
QPreparing the device for use
The mains voltage at the mains socket must match that shown on the rating plate on the device. Devices marked with 230 V can also be operated at 220 V.
Caution! When using the device, never allow the ventilation slots to be covered.
Caution! Danger of burns! Do not touch the hot nozzle.
fire or explosion. |
J Do not work in the vicinity of easily ignitable |
gases or materials. |
Heating of plastics, paints, varnishes etc. can |
lead to the creation of gases that are hazard- |
ous to health. Make sure you always have |
adequate ventilation. |
Switching on the device:
jPress the ON / OFF switch or “II“.
Switching off the device:
jPress the ON / OFF switch
2
2
into setting “I“
into setting “0“.
J Let the device cool down completely before |
you put it into storage. Always place your |
heat gun down on its end, with the nozzle |
pointing upwards. |
J In addition, you should never leave the device |
working unattended. |
J When taking a break from your work, before |
carrying out any tasks on the device itself (e.g. |
changing the nozzle) or when you are not |
Adjusting the air quantity and temperature: You can use the temperature and air quantity control
2to set two different blower levels. It is therefore possible to select the appropriate quantity of air and temperature in accordance with the intended use:
Setting I | 300 l / min | 350 °C |
|
|
|
Setting II | 500 l / min | 550 °C |
GB/IE/CY 9