1
2
1.Socket
2.Anvil
Installing or removing socket
003998
CAUTION:
•Always be sure that the tool is switched off and unplugged before installing or removing the socket.
Align the hole in the side of the socket with the detent pin on the anvil and push it onto the anvil of the tool until it locks into place. Tap it lightly if required.
To remove the socket, simply pull it off.
004000
1
1. Hook
Hook
The hook is convenient for temporarily hanging the tool. This can be removed without using a tool.This can be installed on either side of the tool.
Installing and removing hook
Expand the upper part of the hook in both directions and remove it. To install the hook, follow the removal procedure in reverse.
7