e When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely a couple of times.
e If you wish to charge two battery cartridges, allow 15 minutes betweenchargings on the fast charger.
Selecting correct socket
Use a correct size socket for bolts and nuts. A wrong size socket will result in inaccurate and inconsistent tightening torque. Refer to accessories section for socket size.
Fit the socket over the anvil of the tool and push firmly until the
To remove the socket, simply pull it firm- ly.
Switch action | I |
| |
To start the tool, simply pull the trigger. |
|
Release the trigger to stop. |
|
Trigger switch !l
CAUTION :
Before inserting the battery cartridge into the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.
7
. ... .. . .
.... ... .
. ..... ... ... ...
.
.. .....,.., . .
. . . . .,.... .
.L. . .
.. . ..
.. .. ., ...
. ..... . .