FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
| 002300 | Installing or removing battery cartridge |
1 |
| • Always switch off the tool before insertion or removal of |
|
| the battery cartridge. |
|
| • To remove the battery cartridge, pull out the set plate on |
|
| the tool and grasp both sides of the cartridge while |
2 |
| withdrawing it from the tool. |
•To insert the battery cartridge, align the tongue on the
1. Battery cartridge
2. Set plate
battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure to close the set plate fully before using the tool to prevent the battery cartridge from accidentally falling out of the tool.
•Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly.
|
|
|
|
| 002307 | Charging | ||
|
|
|
|
|
|
| ||
| 1 |
|
|
|
|
| 1. | Plug the battery charger into the proper AC voltage |
|
|
|
|
|
|
| source. | |
|
|
|
|
|
|
| ||
| 2 |
|
|
|
|
| 2. | Insert the battery cartridge so that the plus and minus |
|
|
|
|
|
| |||
| 3 |
|
|
|
|
|
| terminals on the battery cartridge are on the same sides |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| as their respective markings on the charger. Insert the |
|
|
|
|
|
|
|
| cartridge fully into the port so that it rests on the charger |
1. | Battery cartridge |
|
|
| port floor. | |||
2. | Charging light |
|
| 3. When the battery cartridge is inserted, the charging light | ||||
3. | Battery charger |
|
| |||||
|
|
|
|
color will flash in red color and charging will begin.
4.When charging is completed, the charging light goes out.
5.If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its “trickle charge (maintenance charge)” mode.
6.After charging, unplug the charger from the power source.
7