General Operating Instructions
1.WARNING! Use only 3/8” Drive Impact type sockets (sold separately).
2.If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use. Add a few drops more after each hour of continual use.
3.Push and snap the socket (not included) onto the Anvil (31).
4.Slide Reverse Valve (9) to the left for clockwise (forward) rotation. NOTE: This is a sliding valve that is connected to Regulator Knob (12).
5.Place the socket over the nut you wish to tighten.
6.Grip tool firmly with both hands and gently squeeze Trigger (14).
7.Adjust air flow by turning Air
Regulator Knob from positions 1 through 5. Match up desired number setting with the recessed dimple. Position 1 allows the lowest amount of air flow, and Position 5 the highest.
8.If the tool requires more force to accomplish task, verify that the tool receives sufficient, unobstructed airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum air pressure rating of this tool.
9.CAUTION! TO PREVENT TOOL AND ACCESSORY FAILURE, RESULTING IN INJURY:
Do not exceed the tool’s maximum air pressure rating. If tool still does not have sufficient force at maximum pressure and sufficient airflow, then a larger tool may be required.
10.Once nut is tightened, release Trigger. Turn off the air supply and disconnect the hose.
11.If available, check the recommended torque specification for the nut. Use a torque wrench to tighten the nut to the proper setting after using the Impact Wrench.
12.To set Impact Wrench in Reverse, slide Reverse Valve to the right for counterclockwise (reverse) rotation.
Then adjust air flow by turning Air
Regulator Knob from positions 1 through 5. Position 1 allows the lowest amount of air flow, and
Position 5 the highest.
13.WARNING! Before changing the rotational direction of the tool, release the Trigger and allow the tool to come to a complete stop.
14.When the nut is loosened, release Trigger. Turn off air supply and disconnect the hose. If needed, remove the nut from the socket.
15.To prevent accidents, turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/ or turn the switch to its off position after use. Clean external surfaces of the tool with clean, dry cloth. Then store the tool indoors out of children’s reach.
SKU 92453 | For technical questions, please call | Page 9 |