MODEL G0497 |
PLANISHING HAMMER |
INSTRUCTION SHEET |
This machine presents serious injury hazards to untrained users. Read through this entire instruction sheet to become familiar with the controls and opera- tions before starting the machine!
The Model G0497 has a maximum operating pressure of 120 psi. exceeding this maxi- mum can lead to high pressure parts failure, which may cause serious personal injury!
EYE/EAR INJURY HAZARD! Wear safety glasses and hearing protection during use of this tool!
INJURY HAZARD!
Disconnect tool from air and power to prevent accidental operation during service!
CRUSHING HAZARD!
Keep hands clear of hammer mechanism at all times!
Machine Data
Control Power | 110V, |
Blows per Minute | 4600 |
Air Pressure | |
Air Consumption | 12 CFM |
Throat | 24" |
Weight | 168 lbs |
Figure 1. Model G0497 Planishing Hammer.
Introduction
Great for all sheet metal forming, the Model G0497 Planishing Hammer includes an integrated filter/regulator and lubricator, and can shape mild steel up to 16 gauge.
Inventory |
|
Planishing Hammer | 1 |
Mounting and Setup
1.With the help of an assistant, carefully uncrate the planishing hammer.
2.Determine the most suitable location for your planishing hammer based on the planned usage of the machine. Larger workpieces will require a larger space around the planishing hammer.
3.Mount the planishing hammer to the floor using fasteners appropriate for the floor type.
4.Check the oil level in the lubricator. If the oil level is low, refill with an SAE
5.Install a male 1⁄4" NPT quick connector fitting into the air inlet of the planishing hammer.