TROUBLESHOOTING
|
|
|
Problem |
| Possible Solution |
Impact Wrench does not turn on when | 1. Make sure to firmly squeeze the Trigger (27). | |
Trigger is squeezed. | 2. | Make sure air compressor is on and its regulator |
| ||
|
| is set at 90 PSI. |
| 3. | Make sure all air system connections are secure |
|
| and that there are no leaks. |
| 4. | Make sure the air and oil filters in the air compressor |
|
| are not plugged. |
| 5. | Make sure the Air Filter (44) within the Air |
|
| Inlet (45) is not plugged. |
Releasing the Trigger on the Impact | 1. Turn off the air compressor. Release any remaining | |
Wrench does not turn off the tool. |
| compressed air from the system and tool. Disconnect |
|
| the air supply hose from the tool. Do not use the tool |
|
| until a qualified service technician repairs the tool. |
INSPECTION, MAINTENANCE, AND CLEANING
1.WARNING! Always wear ANSI approved safety impact goggles when performing any inspection, maintenance, or cleaning procedures.
2.
WARNING! Prior to performing any inspection, maintenance, or cleaning of the Impact Wrench, make sure to disconnect the air hose from the tool. Then, squeeze the Trigger (27) again to release any compressed air in the system and tool.
3.To clean the exterior of the Impact Wrench, wipe with a clean, damp cloth using a mild detergent or mild solvent. Do not immerse the tool in liquids.
4.When storing, always store the Riveter in a clean, dry, safe location out of reach of children.
5.
CAUTION! All maintenance, service, and repairs not mentioned in this manual must only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 95141 For technical questions, please call