Specifications
Model | 02696 | 00807 |
Torque Range | ||
Drive | 1/4” | 3/8” |
Length | 11” | |
Accuracy | ±4% |
|
Model | 00239 | 00808 |
Torque Range | ||
Drive | 1/2” | 3/4” |
Length | 18” | |
Accuracy | ±4% | |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual before set up or use of this product.
1.Wear
2.Clean and/or repair the threads that will be tightened. Damaged or dirty threads will result in a misleading torque reading.
3.Select the desired socket and verify it fits properly on the nut or bolt being tightened.
4.Press the socket firmly onto the drive anvil.
Lock
Knob
5.Turn the Lock Knob at bottom of the Handle counterclockwise until it stops.
6.Turn the handle to set the torque. To set to 55, for example:
7080
5060
2 1
0 
9 8
(A)
a. Turn the knurled handle (CW or CCW) until the “0” graduation on the bevel edge lines up with 50. See illustration (A), above.
70 | 80 | |
60 | ||
50 | ||
7 6 5 4 3 | ||
(B)
The 50 line is shown in grey because it
will likely be hidden at this point.
b. Continue turning the knurled handle about a half turn clockwise until the “5” graduation mark lines up with the centerline. It is now set for 55. See illustration (B), above.
Torque | For technical questions, please call | Page 3 |
Wrenches |
|
|