Harbor Freight Tools 90374 operating instructions Figure F, To Operate The Jigsaw

Page 13

7.Lightly apply the oscillating Sand Paper Pad (17D) to the workpiece surface, and begin sanding the workpiece by moving the tool forward and backward with (parallel to) the grain of the workpiece.

8.Once the sanding job is completed, release pressure on the Switch (3D) to turn off the Sander. (See Figure F.)

9.IMPORTANT: If, during the sanding process it becomes necessary to replace worn sand paper with new sand paper, make sure to turn off the Sander and disonnect the Battery (1A). Re-install new sand paper and then re-attach the Battery. (See Figure F.)

SAND PAPER

PAD

SANDER(17D)

HANDLE

BATTERY (1A)

FIGURE F

To Operate The Jigsaw:

SWITCH

(3D)

SANDER HANDLE

BATTERY (1A)

1.Make sure the Battery (1A) is disconnected from the Jigsaw prior to attaching the Saw Blade (16E) to the tool.

2.To attach the Saw Blade (16E) to the Jigsaw, use the Hex Key (24E) to loosen the two Hex Socket Screws (14E). (See Figure G, next page.)

3.Insert the shank of the Saw Blade (16E) upward into the Blade Holder (15E) with its saw teeth pointing to the front of the tool. Then, re-tighten the two Hex Socket Screws (14E) to secure the Saw Blade in place. (See Figure G.)

4.If desired, the angle of a cut may be adjusted. To do so, loosen the Hex Socket Screw (14E) located on the underside of the Sander. Tilt the Base Plate (19) to the desired angle. Then, re-tighten the Hex Socket Screw. (See Figure G.)

SKU 90374

PAGE 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents For technical questions, please call 18V Cordless Combo PackWork Area General Safety RulesRead and Understand ALL Instructions Personal Safety Electrical SafetyREV 03j Tool USE and CareGrounding ServiceDouble Insulated Tools Tools with TWO Prong Plugs Extension CordsSee Figure C, below See Figure CFigure C Specific Safety Rules SymbologyREV 04f Industrial applications must follow Osha requirements Do not allow children to handle or play with these productsUnpacking Assembly and Operating InstructionsSee Figure D See Figure E, next To Operate The FlashlightREV 03j, 04f, 07k To Operate The Sander See Figure ETo Operate The Jigsaw Figure FFigure G See Figure GFigure H To Operate The DrillSee Figure H INSPECTION, MAINTENANCE, and CleaningPlease Read the Following Carefully Assembly Diagram Flashlight Parts List FlashlightAssembly Diagram Sander Parts List SanderCharger Base Not shownAssembly Diagram Jigsaw Parts List JigsawDescription Parts List DrillAssembly Diagram Drill
Top Page Image Contents