CHARGER BASE (50)
BATTERY (30)
Tabs
Tabs
NOTE: To connect the Charger Base (50) to the Battery (30), press in the tabs on the Battery while you slide the Charger Base forward.
FIGURE 1
GREEN POWER
INDICATOR
LIGHTTabs
CHARGER BASE (50)
| PLUG INTO |
| 120 VOLT, GROUNDED, |
| ELECTRICAL OUTLET |
RED CHARGING |
|
INDICATOR |
|
LIGHT | FIGURE 2 |
OPERATING INSTRUCTIONS
1.Before installing the Socket (49), make sure the Battery (30) is removed from the Impact Wrench to avoid accidental starting. Then, firmly insert and lock in place the Socket onto the 1/2” Impact Head of the tool.
2.Whenever possible, secure the work piece in place, using a vise or clamps (not included).
3.Insert the fully charged Battery (30) into the Handle of the Impact Wrench, and rotate the Battery 180 degrees to lock the Battery in place.
4.Use the Forward/Reverse Button to select the turning rotation of the Impact Wrench.
5.Insert the Socket (49) onto the nut that is to be loosened/tightened. NOTE: If using the accessory 1/2” Socket, the nut itself must be 1/2”.
6.Make sure to hold the Impact Wrench firmly with both hands, as torque from the Motor will cause the tool to twist. Then, squeeze the Trigger Switch (21) to turn on the Impact Wrench. The more you depress the Trigger Switch (21) the faster the Impact Wrench will turn.
7.When finished, release the Trigger Switch (21) to stop the Impact Wrench. Then, remove the Battery (30) and Socket (49) from the tool.
SKU 94855 | PAGE 12 |