Troubleshooting Guide
| Trouble | Probable Cause | Solution |
|
|
|
|
|
| Couplers are not securely attached to | Check the Coupler connections and make |
|
| the tool or pump | certain that they are connected. |
| Piston will not advance or | Coupler is defective | Replace any defective Coupler. |
| retract |
|
|
| Defective remote control switch | Replace the switch and/or control pendent | |
|
| ||
|
| Dirt in the | Disassemble the pump and clean the |
|
| the pump unit | |
|
|
| Make certain the advance on the pump is |
|
| Hose connections reversed | connected to the advance on the tool and |
|
| retract on the pump is connected to the | |
|
|
| |
| Piston will not retract |
| retract on the tool. |
|
| Retract hose not connected | Connect the retract hose securely |
|
|
|
|
|
| Retract pin and/or Spring broken | Replace the broken pin and/or spring |
|
|
|
|
|
| Piston Seal and/or End Plug Seal | Replace any defective |
|
| leaking | |
| Cylinder will not build up |
| |
| Retaining Screws sheared | Replace any broken screws. | |
| pressure | ||
|
| Coupler is defective | Replace any defective Coupler |
|
|
|
|
|
| Grease or dirt build up in the teeth of | Disassemble the Ratchet and clean the |
| Ratchet will not turn | the Ratchet and Segment Pawl | grease or dirt out of the teeth |
| Worn or broken teeth on Ratchet an/or | Replace any worn or damaged parts | |
|
| ||
|
| Segment Pawl | |
|
|
| |
| Tool tightens immediately |
| Depress the advance button to release the |
| Hose connections are reversed | tool; shut the pump off in the advance | |
| when turned on | ||
|
| position and reverse the hose connection | |
|
|
| |
|
| Defective relief valve | Inspect, adjust or replace the relief valve |
|
|
| Make certain the air supply and hose size |
|
| Air supply too low or air hose too small | comply with the pump manual |
|
|
| recommendations. |
|
|
| Make certain the amperage, voltage and |
| Pump will not build up | Electric power source is too low | any extension cord size comply with the |
| pressure |
| pump manual requirements |
|
| Defective Gauge | Replace the Gauge |
|
|
|
|
|
| Low oil level | Check and fill the pump reservoir |
|
| Clogged filter | Inspect, clean and/or replace the pump |
|
| filter | |
|
|
| |
| Pressure reading erratic | Defective Gauge | Replace the Gauge |
|
|
|
|
| Nut Returns with retract | Ball Plungers are not engaging the | Thread the Ball Plungers to the correct |
| stroke | Drive Sleeves | depth in the Housing. |
NOTICE
SAVE THESE INSTRUCTIONS. DO NOT DESTROY.
- 14 -