Chicago Electric 96531 Cleaning, maintenance, and lubrication, Replacing the Soldering Iron

Page 13

(4), and unplug the tool from its electrical outlet before performing inspection, maintenance, or cleaning procedures.

Damaged equipment can fail, causing personal injury. Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.

Cleaning, maintenance, and lubrication

1.BEFORE EACH USE, inspect the general condition of the tool. Check for dam- aged Soldering Iron (15) tip, loose screws, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.

2.After Use, clean external surfaces and Soldering Tip.

3.WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.

Replacing the Soldering Iron

1.If Soldering Tip cracks or becomes eroded it must be replaced. The Soldering Tip cannot heat up properly when cracked or eroded.

Heating Contact (17)

Tip Retainer (16)

Soldering Iron (15)

2.Turn Power Switch (4) to the “OFF” position and unplug the Soldering Station from the electrical outlet. Allow adequate time for all surfaces to cool down.

3.Unscrew Tip Retainer (16) that holds the Soldering Iron (15) onto the Heating Contact (17) and remove the Soldering Iron. It may be necessary to force the Soldering Iron (15) out of the Tip Retainer (16). To do this, place the Soldering Iron on the side of the work bench, hold the Tip Retainer, and push on it towards the Soldering Tip, forcing it out. Be sure to wear ANSI-approved safety goggles and heavy-duty work gloves while doing this.

4.Place new Solder Tip on Heating Contact, replace Retainer, and finger-tighten.

Replacing the Fuse

1.Turn the Power Switch (4) to the “OFF” position, unplug the Soldering Station from the outlet, and allow time for all surfaces of the unit to cool down completely.

2.Turn the Soldering Station over and use a screwdriver to remove the cover marked “FUSE” on the bottom.

3.Remove the old fuse and replace with a new 6.3A/250V fuse of the same type. Replace cover and screw back into place.

SKU 96531

For technical questions, please call 1-800-444-3353.

Page 13

Image 13
Contents Digital soldering station For technical questions or replacement parts, please callContents Save This Manual Important Safety InformationGeneral Safety Rules Power tool use and care Grounding Specific Safety RulesDouble Insulated Tools Tools with Two Prong Plugs Grounded Tools Tools with Three Prong PlugsExtension Cords See 3-Prong Plug and Outlet Outlets for 2-Prong PlugFeet See Table aSet Up Instructions SpecificationsSymbology List of contentsOperating Instructions Tool set upFunctions General operating instructions Work piece set upSoldering Tips SKU For technical questions, please callPosition, as marked with an O below the Power Switch Maintenance And ServicingRisk of serious personal injury from accidental starting or Replacing the Soldering Iron Cleaning, maintenance, and lubricationReplacing the Fuse Part Description Qty Parts List & assembly diagramRecord Product’s Serial Number Here Limited 90 DAY Warranty