Ryobi HPL50 manual Correct Wrong

OPERATION

CAUTION:

Planing too fast increases chip build-up in the chip exhaust and can result in a poor finish. Chip build- up restricts air flow and can cause motor overheating. Plane slowly and empty dust bag often to prevent damage.

WARNING:

Do not attempt to clear a blocked chip exhaust until the blades have stopped and the unit has been disconnected from the power source. Failure to heed this warning can result in serious personal injury.

Keep cord away from cutting area. Always place the cord to prevent it from hanging on the work while cutting.

DANGER:

If the cord hangs up on the work during a cut, release the trigger switch immediately. Unplug your planer and check cord for damage. If no damage, reposition the cord to prevent it from hanging up again. If the cord has been damaged, have it replaced before using your planer.

WARNING:

Using your planer with a damaged cord could cause electrical shock resulting in serious injury.

Know the right way to use your planer. See Figure 5.

Never use your planer as shown in Figures 6 and 7.

Always keep control of your planer. It makes cutting easier and safer. To help keep control, always support your work so the cut will be on your right. Clamp your work so it will not move during the cut. See Figure 5. The work moving during a cut could result in the loss of control of your planer possibly causing serious injury.

CORRECT

Fig. 5

WRONG

Fig. 6

WRONG

Fig. 7

10