RULES FOR SAFE OPERATION
Anti-Kickback Pawls
Device which, when properly installed and maintained, is designed to stop the workpiece from being kicked back toward the front of the Blade during a Planer operation.
Avoiding kickback
Always use the correct Blade depth setting.
Inspect the work for knots or nails before beginning a cut. Knock out any loose knots with a hammer, never cut into a loose knot or nail.
Always use clear, sharp, and
To avoid pinching the Blade, support the work properly before beginning a planer operation.
When making a planer operation, use steady, even pressure, never force to plane.
Do not plane wet or warped timber.
Always hold your workpiece firmly with both hands, keep your body in a balanced position to be ready to resist kickback. Never stand directly in line with timber.
LOOSE PARTS LIST
| 1 |
|
|
| 9 |
| 3 | 4 | 5 | 6 | |
2 |
| ||||
|
|
|
|
|
| 7 | 8 | 10 |
|
| ||
|
|
| • Properly assembled |
|
|
| blade setting guage. |
1) “C” Circlip | 4 pieces | ||
2) | Blade Setting Guide | 2 pieces | |
3) | Blade Setting Guage Shaft | 1 piece | |
4) | Base Lock Screw | 8mm x 50(L) | ................................................................................... 4 pieces |
5) | Elevation Knob Lock Screw | 6mm x 15(L) | 1 piece |
6) | Cutterhead Raising Hand Crank | 1 piece | |
7) | Allen Wrenches | 4 & 5mm | |
8) | Open End Wrench | 8 x 10 | 1 piece |
9) | Dust Chute | 1 piece | |
10) Philip Screws | 4 pieces | ||
Page 4