ADJUSTMENT
MAKING THE CUTTERHEAD AND WORKTABLE PARALLEL (Fig. 9~12)
Plane a workpiece and measure thickness after the cut. If the thickness is not the same on both sides of the workpiece, perform the following action.
Adjust the cutter shaft and the worktable so they are parallel. The tools used for checking are shown below
.Please use hardwood to make a tool guage block according to the size shown in the figure 9. Make the adjustments as per the following procedures.
Remove height adjustment handle and both top and side covers by removing allen screws (Fig.11) to expose height adjustment lock nuts. (Fig.12)
Loosen adjustment lock nut. (Fig.12)
Adjust height nut up or down as required to suit guage block. (Fig.10)
When desired height setting is reached, tighten lock nuts inposition. (Fig.12)
Reassemble side and top covers and replace height adjustment handle.
Fig. 10
Height Adjustment 
Crank Handle
34mm
135° | 33mm |
20mm
5mm
33mm
Allen
Screws
Fig. 11
120°
100mm
3mm
Height
Adjustment Nut
70mm 
15mm 100mm
30mm
Fig. 12
Fig. 9
Page 8