Epson 22-681 instruction manual Assembling Switch to Planer Three Phase Machine only

Page 10

ASSEMBLING SWITCH TO PLANER (THREE PHASE MACHINE ONLY)

The switch for the three phase 15² Planer is supplied wired to the motor and is to be fastened to the planer as follows:

C

A

B

B

A

Fig. 10A

1.Line up the two holes (A) Fig. 10A, in the switch bracket (C) with the two threaded holes (B) in the left front of the machine.

C

D

Fig. 10B

2. Fasten the switch bracket (C) Fig. 10B, to the planer using the two screws and flat washers (D) as shown.

10

Image 10

Contents DC-380 15 Planer Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionImportant Safety Instructions General Safety RulesStay ALERT, Watch What YOU are DOING, Additional Safety Rules for Planers Refer to them often Use them to instruct othersMotor Specifications Power ConnectionsGrounding Instructions Extension Cords Three Phase OperationFunctional Description ForewordCarton Contents Cuttinghead Raising and Lowering Handwheel AssemblyAssembly Tools Required Lifting the MachineAssembling Switch to Planer Three Phase Machine only Assembling TOP Cover and Dust Chute Assembling Accessory StandLifting the Machine Operation Locking Switch in the OFF PositionStarting and Stopping Machine Depth of CUT Adjustment Feed Speed ControlDisconnect Machine from Power Source Adjusting Belt TensionANTI-KICKBACK Fingers CHECKING, Adjusting and Replacing Knives Constructing Gage Block Adjusting Height Chipbreaker Replacing KnivesAdjusting Height Infeed Roller Adjusting Height Outfeed RollerAdjusting Spring Tension of Infeed and Outfeed Rollers Adjusting Table RollersAdjusting Cuttinghead Parallel to Table Troubleshooting Machine USECleaning Infeed and Outfeed Rollers MaintenanceKeep Machine Clean Protecting Cast Iron from RustAccessories ServiceWarranty Canadian PORTER-CABLE Delta Service Centers