Grizzly manual Accessories, H9893 Carbide Inserts Model G0634XP Mfg /11+

Page 12

4.Clean all dust and dirt off the insert and the cutterhead pocket from which the insert was removed, and replace the insert so a fresh, sharp edge is facing outward.

Note: Proper cleaning is critical to achieving a smooth finish. Dirt or dust trapped between the insert and cutterhead will slightly raise the insert, and make noticeable marks on your- workpieces the next time you plane.

5.Lubricate the Torx screw threads with a light machine oil, wipe the excess oil off the threads, and torque the Torx screw to 55 inch/ pounds.

Note: Do not overlubricate. Excess oil may squeeze between the insert and cutterhead, thereby lifting the insert slightly and affecting workpiece finishes.

Accessories

H9893—Carbide Inserts (10 Pk) for G0634XP These indexable carbide inserts can be rotated to provide four factory sharp edges before replace- ment. Size: 15 x 15 x 2.5mm.

Figure 12. H9893 Carbide Inserts.

-12-

Model G0634XP (Mfg. 4/11+)

Page 11 Page 12
Image 12
Page 11 Page 12
Contents Machine Inventory Spiral Cutterhead Hardware FigureStand Assembly Parts Breakdown Table Assembly Parts BreakdownCutterhead & Motor Parts Breakdown DescriptionFence/Guard Parts Breakdown PCAP03Machine Data Sheet Cutting Capacities Planer Availability Full-Load Current RatingCircuit Requirements for Grounding Instructions Extension CordsMinimum Gauge Size 10 AWG 50 ft To set up the machine for planer operations Basic Jointer Controls Jointer-Planer Conversion Lubrication Setting Fence Stops Tools Needed QtyTo set the 90˚ fence stop Replacing Carbide Inserts To set the 45 fence stopTo rotate or change a carbide insert Accessories H9893 Carbide Inserts Model G0634XP Mfg /11+
Top Page Image Contents