Grizzly instruction manual Spring Tension, Tension screw locations G1033 20 Planer

Page 19

A

Figure 17. Feeler measures roller adjustment.

8.Move the feed speed control knob to the center neutral position.

9.Rotate the sprocket at the end of the infeed roller. The teeth at the bottom of the roller should contact the top of the block if the roller is properly adjusted. If the roller teeth will not clear the block, or if there is a gap between the block and the infeed roller, you will need to make adjustments.

10.If you need to adjust the roller up or down, loosen the lock nut and turn the setscrew to raise or lower the rollers. See Figure 18.

Figure 18. Adjusting roller height.

11.Follow the same procedure at the other end of the infeed roller and on both sides of the outfeed roller. Do not change the table height yet, the next sections will require the same settings.

12.Be sure to tighten the lock nut as soon as you have adjusted each roller to its proper height.

Spring Tension

Roller spring tension must be adjusted so that roller pressure is uniform. To adjust roller spring tension:

1.Locate the four adjustment screws located on the top of the planer. See Figure 19.

2.Adjust screws #1 - #3 so that they protrude 1Ú8" above the head casting.

3.Adjust screw #4 so that it protrudes 5Ú16" above the head casting.

Tension screws #1 - #3

Tension screw #4

Figure 19. Tension screw locations.

G1033 20" Planer

-17-

Image 19
Contents Planer Page Table Of Contents Safety Instructions For Power Tools SafetyAMP Rating Additional Safety Instructions For Planers Extension Cords FusingCircuit Requirements 220V Operation GroundingCommentary IntroductionParts Inventory UnpackingSite Considerations Clean UpHand Wheel AssemblyOverview Extension RollersAttaching switch Dust Hood SwitchKnife setting jig Knife Setting JigChain Adjustment Table Adjustment AdjustmentsChain Drive Micro-adjustment screws G1033 20 PlanerBed Rollers Knife Inspection Knife AdjustmentFeed Roller Speed Roller AdjustmentTension screw locations G1033 20 Planer Spring TensionChipbreaker Pressure Bar Chip Deflector Static Chain AdjusterAnti-Kickback Fingers Scale AdjustmentTest Run Operational Tips OperationsWood Characteristics General MaintenanceKnife Sharpening Feed roller lubrication points G1033 20 Planer LubricationBelt Tension Belt Alignment Closure Machine Data Sheet Symptom Possible Cause Corrective Action Troubleshooting107 108 8894 109 Description Middle Table 297 2810 Stand Gear BOX PSB18M G1033 20 Planer G1033 Wiring Diagram -Taian Type Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC