12.REMOVE ADJUSTING KEYS AND WRENCHES. Be sure that keys and adjusting wrenches are removed from the tool or machine work surface before operation.
13.AVOID UNINTENTIONAL STARTING. Be sure that you are prepared to begin work before turning the start switch on.
14.STAYALERT. Watch what you are doing. Do not operate this machine when you are tired.
15.DO NOT OPERATE THIS MACHINE WHILE UNDER THE INFLUENCE OF ALCOHOL, DRUGS, OR PRESCRIPTION MEDICINES.
16.CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if any switch does not turn on and off properly.
17.REPLACEMENT PARTSANDACCESSORIES. When servicing, use only identical replacement parts intended for use with this tool. Replacement parts are available from Harbor Freight Tools. Use of any other parts will void the warranty.
SPECIAL WARNINGS WHEN USING THIS PLANING MACHINE
Using this Planer may create special hazards.
Take particular care to safeguard yourself and those around you.
Electrical Safety. Never operate any tool if there is an electrical hazard. Never operate an electrical tool in wet conditions. Never operate a tool with an improper electrical cord or extension cord. Never operate an electrical tool unless it is plugged into a properly grounded outlet, which supplies
Ejected Material. Use safe practices to avoid injury from ejected material. Because the Planing tools turn at high speed, there is a danger of being injured by materials that may be ejected. Always wear ANSI- certified eye protection. Always stand to one side of the line in which the materials are being inserted or extruded, to avoid being hit if particles are ejected. Never allow bystanders to be in the proximity of the Planer while in operation.
Jamming. Avoid causing the planer to bog down or jam by avoiding the following situations. Do not attempt to plane more than 1/8” at a time, or less if the wood is very hard. Do not attempt to feed more than the stated feed rate, or less if the wood is very hard. Be sure your knife blades are kept sharp. Check all workpieces for knots and foreign objects before planing. If the workpiece jams, it is likely the circuit breaker will break to protect the motor.
Entanglement. Use extreme caution to prevent loose materials from being caught in the machine. Never operate this Planer with loose clothing, long hair, jewelry, or other items which may become caught in the blades or workpieces. In case of entanglement, press the OFF switch immediately.
NOTICE: No list of warnings can be all inclusive.
The operator must supply common sense, and operate this tool in a safe manner.
Page 4 SKU # 41831