Harbor Freight Tools 41831 Attaching the Carrying Handles, Installing the table extensions

Page 6
Figure 2. Table Extension Adjustment

COMPLETING ASSEMBLY

WARNING: Be sure the machine is unplugged before attempting any assembly or adjustment operation.

Attaching the Carrying Handles

1.Locate the two carrying handles (#349), and their hardware, Screws (#327).

2.Attach the handles to the top of the machine using the screws. Be sure the handles are firmly attached.

Installing the table extensions

1.With the roller up, place each table extension bracket (#157) onto the table (#125) and attach using two cap screws (#164). Be sure the bracket assemblies are firmly attached, but are able to rotate up for storage.

2.Adjust each table extension so that a workpiece supported by the roller is level and in the same plane

with the table. Do this by adjusting the cap screws (#1) in or out as required. See Figure 2. Check

the adjustment by placing a straight edge at least 24” long through the machine, and resting on the table and both extension rollers. When the extension is properly adjusted, lock the cap screws in place with the lock nuts (#2).

Setting the Cutting Depth

1.Place the Table Adjustment Handle (#150) over the square-ended ControlScrew (#130)whichprotrudesthroughtthetopofthemachine.

2.Turn the Table Adjustment Handle to raise or lower the Table to the desired cutting thickness.

3.Read the cutting depth reading on the scale on the right of the machine.

4.RemovetheTableAdjustmentHandle beforeoperatingthe machine.

Operating the Power Switch

1.The power switch is located on the lower right front of the machine.

2.The Safety Switch Cover may be installed or removed by pressing it onto or pulling it off of the power switch.

3.The Safety Switch Cover must be in place to operate the Power Switch. You can remove the Cover and store it in a safe place to prevent unauthorized use of the machine.

4.Press the Switch UP to turn the machine ON, and DOWN to turn the

machine OFF.

Fig. 3

Crank and

 

Cutting

Depth Scale

Integral Circuit Breaker.

 

1.

The circuit breaker will automatically break if more than 10AMPS

Fig. 4 Power Switch and

reaches the motor. This will help prevent motor burn out in case the planer

jams, or there is a power surge through the power cord.

Integral Circuit Breaker

2.

To reset, correct the error condition, and press the button back in.

Page 6 SKU # 41831

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Auto Planer Features SpecificationsIncluded Accessories Read ALL Instructions Before Using this ToolPage Special Warnings When Using this Planing Machine Installation Electrical PowerUnpacking Operating the Power Switch Installing the table extensionsSetting the Cutting Depth Attaching the Carrying HandlesSafety Check Prior to Operation OperationSelect your wood with care It is important to consider wood grain when planingSuggestions for Better Planing Plan the best way to handle warped and bowed boardsMaintenance Adjusting the Cutting KnivesMotor and electrical controls should be maintained If the Motor runs rough or slowly TroubleshootingIf the Planer will not operate at all Changing the Carbon Brushes#41831 12-1/2 Auto Planer Parts LIST, Main Unit Please refer to Parts Diagram on#41831 12-1/2 Auto Planer Parts DIAGRAM, Main Unit Please refer to Parts List onMotor Assembly #41831 12-1/2 Auto PLANER, Additional Parts ListPlease refer to Parts Diagrams on Page 14 Cutter Assembly#41831 12-1/2 Auto Planer Parts DIAGRAM, Motor Assembly #41831 12-1/2 Auto Planer Parts DIAGRAM, Cutter Assembly
Top Page Image Contents