Harbor Freight Tools 95838 manual Features and Controls, Trigger and Safety Switch, Fence

Page 11

Features and Controls

Dust

Safety Switch (51)

Trigger (48)

Bag (46)

 

 

 

Exhaust Direction

 

 

Lever (55)

 

Wrench

Handle (47)

Rabbet Depth

Guide (17)

(Hidden from view)

Depth

Adjustment

Knob (24)

Fence (37)

1.Trigger and Safety Switch:

As a safety feature, the Safety Switch (51) must be pushed to one side to allow the Trigger (48) to operate.

2.Wrench Handle storage:

The Left Housing (3) has a slot to allow storage of the Wrench Handle (47) and Wrench (49).

3.Fence:

The Fence (37) can be adjusted to control the width of the cut from the edge of the workpiece. The Fence can only be installed on the Left Housing. It is held in place by the Locking Knob (18).

To adjust: Loosen the Wing Nut (38), slide the Fence (37) to the desired setting. Retighten the Wing Nut after adjustment.

Note: The Bolt (40) needs to be inserted through the Fence from the top down with the Washer (39) underneath the fence, otherwise the flats on the Bolt will not properly engage the Fence Bracket (41).

The markings on the Fence are intended as general guidelines only. For accurate measurements, verify the position of the Fence using a measuring tool after tighten- ing.

Page 11

For technical questions, please call 1-800-444-3353. SKU 95838

Image 11
Contents Distributed exclusively by Harbor Freight tools For technical questions or replacement parts, please callSave This Manual SpecificationsGeneral Safety Rules Electrical SafetyPersonal Safety Tool Use And Care ServiceKeep the extension cord away from moving parts on the tool Specific Safety RulesSee 3-Prong Plug and Outlet GroundingGrounded Tools Tools With Three Prong Plugs See Table a Double Insulated Tools Tools With Two Prong PlugsExtension Cords Prong Plug and Outlet Outlets for 2-Prong PlugAt full load SymbologyFeet 120 or 240 VoltUnpacking Set upKnife Installation and Adjustment For technical questions, please call 1-800-444-3353. SKU Fence Features and ControlsTrigger and Safety Switch Wrench Handle storageDust Bag and Exhaust Direction Lever Depth Adjustment Knob and Depth Knob ScaleOperation Thickness PlaningRabbeting Chamfering Edges INSPECTION, MAINTENANCE, and CleaningMonths TroubleshootingProblem Possible Causes Probable Solutions Part Description ’ty Parts ListRecord Product’s Serial Number Here Assembly Diagram Limited 90 DAY Warranty Knife Assembly Diagram