Fence Use and Installation
Step 1: The FENCE (#65) can only be used when edge of stock is flat and at a 90° angle to the surface being plane.
Step 2: The Fence must be used to engage is Rabbeting Procedures (see below).
Step 3: To install the FENCE, first loosen the front KNOB (#61) by turning it counterclockwise. (See Figure 2.)
Knob (#61)
Fence
(#65)
Figure 2 — Using the Fence
Step 4: Insert the fence into the hole as shown in Figure 2.
Step 5: Though the FENCE is shown being installed in the right side, it can be positioned on the left as well.
Step 6: Set the fence so that it rests against the edge of the stock and so that the cutterhead is positioned to plane the desired area.
Step 7: Tighten the KNOB by turning clockwise.