Makita 2030N instruction manual Additional Safety Rules for Jointer

ADDITIONAL SAFETY RULES FOR JOINTER

1.Maintain the proper relationships of infeed and outfeed table surfaces and cut- terhead blade path.

2.Do not perform jointing operations on material shorter than 140 m m (5-112 inches), narrower than 19 m m (3/4 inch), or less than 12.7 mm (112 inch) thick.

3.Do not perform planing operations on material shorter than 140 m m (5-1/2 inches), narrower than 19 m m (314 inch), wider than 155 m m (6-118 inches) or thinner than 12.7 mm (1/2 inch).

4.Support the workpiece adequately at all times during operation.

5. Do not back the work toward the infeed table.

6.Always use hold-downlpush blocks for jointing material narrower than 76.2 mm (3inches), or planing material thinner than 76.2 mm (3inches).

SAVE THESE INSTRUCTIONS.

ADDITIONAL SAFETY RULES FOR AUTO-PLANER

1.Two or more pieces of narrow but similar thickness stock can be passed through the auto-planer side by side.

However, allow some spacing between the stock to permit the feed rollers t o grip the thinnest piece.

Otherwise, a slightly thinner piece could be kicked back by the cutterhead.

WARNING

For Your Own Safety, Read Instruction Manual Before Operating Jointer

1.Wear eye protection.

2.Never perform jointing or planing operation with cutter head or drive guard removed.

3.Never make jointing or planing cut deeper than 3.2mm (1/8 inch).

4.Always use hold-downlpush blocks for jointing material narrower than 76.2 mm (3inches), or planing material thinner than 76.2 m m (3inches).

5.Do not attempt t o perform an abnormal or little-used operation without study and the use of adequate hold-down1push blocks, jigs, fixtures, stops, etc.

SAVE THESE INSTRUCTIONS.

6