For tool with standard planer blades |
| |
| 1. | Socket wrench |
1 |
|
|
007641 |
|
|
1 | 1. | Bolt |
| 2. | Drum |
| 3. | Planer blade |
| 4. | Drum cover |
2 | 5. Adjusting plate | |
|
| |
3 |
|
|
4 |
|
|
5 |
|
|
002555 |
|
|
For tool with mini planer blades
1.Remove the existing blade, if the tool has been in use, carefully clean the drum surfaces and the drum cover. To remove the blades on the drum, unscrew the three installation bolts with the socket wrench. The drum cover comes off together with the blades.
1.Socket wrench
1
007641
2.To install the blades, loosely attach the adjusting plate to the set plate with the pan head screws and set the mini planer blade on the gauge base so that the cutting edge of the blade is perfectly flush with the inside flank of the gauge plate.
2
31
5 |
|
6 | 8 |
7 |
|
| 9 |
002556 |
|
To remove the | blades on the |
1.Inside edge of gauge plate
2.Blade edge
3.Planer blade
4.Adjusting plate
5.Screws
6.Heel
7.Back side of gauge base
8.Gauge plate
9.Gauge base
drum, unscrew the
1
2 | 5 |
| |
3 | 6 |
4 | 7 |
8 | |
| 9 |
| 10 |
1. | Pan head screw |
2. Adjusting plate | |
3. | Planer blade |
| locating lugs |
4. | Gauge plate |
5. | Heel of |
| adjusting plate |
6. | Set plate |
7. | Inside flank of |
| gauge plate |
8. | Gauge base |
9. | Back side of |
| gauge base |
10. Mini planer | |
installation bolts with the socket wrench. The drum cover comes off together with the blades.
002565
blade |
To install the blades, first clean out all chips or foreign matter adhering to the drum or blades. Use blades of the same dimensions and weight, or drum oscillation/vibration will result, causing poor planing action and, eventually, tool breakdown.
Place the blade on the gauge base so that the blade edge is perfectly flush with the inside edge of the gauge plate. Place the adjusting plate on the blade, then simply press in the heel of the adjusting plate flush with the back side of the gauge base and tighten two screws on the adjusting plate. Now slip the heel of the adjusting plate into the drum groove, then fit the drum cover on it. Tighten all the installation bolts evenly and alternately with the socket wrench.
3.Set the adjusting plate/set plate on the gauge base so that the planer blade locating lugs on the set plate rest in the mini planer blade groove, then press in the heel of the adjusting plate flush with the back side of the gauge base and tighten the pan head screws.
4.It is important that the blade sits flush with the inside flank of the gauge plate, the planer blade locating lugs sit in the blade groove and the heel of the adjusting plate is flush with the back side of the gauge base. Check this alignment carefully to ensure uniform cutting.
5.Slip the heel of the adjusting plate into the groove of the drum.
6.Set the drum cover over the adjusting plate/set plate and screw in the three hex flange head bolts so that a gap exists between the drum and the set
6