Makita 1002BA instruction manual Adjusting depth of cut, Adjusting front base, Switch action

Adjusting depth of cut

Depth of cut may be adjusted by simply

turning the knob on the front of the tool. Knob

1

Adjusting front base

The front base is factory-adjusted to allow concave cuts with a radius of 320 mm. For concave cuts with the tool’s minimum radius of 300 mm, loosen the wing bolt on either side and raise the front base as far as it will go. Then retighten the two wing bolts firmly to secure the front base.

Wing bolt

Switch action

To start the tool, simply pull the trigger. Release the trigger to stop. For continuous operation, pull the trigger and then push in the lock button. To stop the tool from the locked position, pull the trigger fully, then release it.

CAUTION:

Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released.

6