MAINTENANCE
CAUTlON:
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
Replacingcarbon brushes |
|
|
Remove and check the carbon brushes |
|
|
regularly. Replace when they wear down to |
|
|
the limit mark. Keep the carbon brushes |
|
|
clean and free to slip in the holders. Both |
|
|
carbon brushes should be replaced at the |
|
|
same time. Use only identical carbon |
|
|
brushes. | I |
|
| Limit mark | |
|
| |
Use a screwdriver to remove the chip |
|
|
cover. |
|
|
1 // Sdrewdriver Chipcover
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
I | Brush holder cap | \ |
|
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjust- ment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
8