Align the blade edge with the mark and make the drum stationary by means of the stopper pin. Place the leveller over the rear base and blade, and press the leveller down slightly. Release the stopper pin.
Stopper pin
When released | When secured |
~
Turn the drum in the direction of the I arrow (Fig. 6) to check the blade protru- sion, holding the leveller flush against the blade and rear base. The blade edge should just contact the underside of the leveller. When the blade edge does not protrude far enough from the base, press down on the pin in the middle of the drum with the socket wrench handle, and adjust the blades again as mentioned above. After adjusting both blades, tighten the four in- stallation bolts evenly and alternately with the socket wrench.
Fig.
Rse
I
Fig.
CATU ION :
Tighten the blade installation bolts carefully when attaching the blades to the tool. A loose installation bolt can be dangerous. Always check to see they are tightened securely.
6