First, loosen the two wing nuts on the |
|
holder and insert the blades (A) and (B) |
|
so that they contact the sides (C) and (D). I |
|
Then tighten the wing nuts. | Wing nut |
Side (C)
Fig. 1
Immerse the dressing stone in water for 2 or 3 minutes before sharpening. Hold the holder so that the blades both contact the dressing stone for simultaneous sharpening a t the same angle.
Fig. Id
MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
The tool will stop when the carbon brushes wear to a certain length. When this occurs, both carbon brushes should be replaced.
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
9