“Ready to wear”:
-Starts to illuminate when the drying degree reaches “Ready to wear” step and remains illuminated until the next step.
“Final / Anti-creasing”:
-Illuminates when the programme comes to an end and
CIf more than one LED light up or flash concurrently, it means there is malfunctioning or a failure (please see, Solution suggestions for problems).
start the programme.
CAny laundry added after the drying process has started may cause the already dried clothes in the machine
to intermingle with wet clothes and the drying result will not be as good.
CLaundry may be added or taken out as much as desired during a drying process, but as this process will interrupt drying continuously, it will extend the programme duration and increase energy consumption. Therefore, it is recommended to add laundry before the drying programme is started.
Changing the programme after the programme has started
You can use this feature after your machine has started to dry your clothes under higher or lower temperatures.
For example;
Press and hold the “Start/Pause/Cancel” button for about 3 seconds to “Cancel” the programme in order to select “Extra Dry” programme instead of “Iron Dry” programme.
Select the “Extra Dry” programme by rotating the programme knob.
Press “Start/Pause/Cancel” button to start the programme.
CThe programme which is selected first will go on even if the programme selection button is moved and another programme mode is selected while the machine is operating. You must cancel the ongoing programme in order to change the drying programme. (See. Ending the programme through cancelling)
Adding/removing laundry in standby mode
In order to add or take out laundry after the
1.Press the “Start/Pause/Cancel” button to switch the machine to “Pause” mode. Drying process will stop.
2.Open the door at “Pause” position and close it again after adding or taking out laundry.
3.Press “Start/Pause/Cancel” button to
Child-proof lock
There is a childproof lock to prevent any programme interruption due to the pressing of keys while the programme is on. The loading door and all keys except the “On/Off” key on the panel are deactivated when the
In order to activate the childproof lock, press on the “Start/Pause/Cancel” and “Cancel audio warning” buttons simultaneously for 3 seconds.
To start a new programme after the programme is over or to interrupt the programme, the childproof lock should be deactivated. To deactivate the
C2 beeps when activating and 1 beep when deactivating the
Ending the programme through canceling
The programme which is selected first will keep on going even if the position of the programme selection button is changed. A new programme can be selected and started after “Programme cancel” is
17 - EN