Stow CS403016 CS403020 CS403026 CS403030 manual Control Panel Decals

CONTROL PANEL DECALS

CONTROL PANEL DECALS

1

THROTTLE		AUXILIARY	LIGHTS		BLADESHAFT
				ON	DIS-ENGAGE
		ON
TO INCREASE ENGINE SPEED:	TURN KNOB COUNTERCLOCKWISE .
TO REDUCE ENGINE SPEED:	TURN KNOB CLOCKWISE.
FOR QUICK THROTTLE ACTION:	DEPRESS RED BUTTON AND	OFF		OFF	ENGAGE
PUSH OR PULL KNOB.
				OPERATING INSTRUCTIONS
			BEFORE		Check all fluid levels. Secure blade firmly to
			STARTING:		bladeshaft. Make sure all protective guards
					are in place and properly mounted. Wear eye,
	2				ear protection and protective clothing.
			WATER		Connect water supply to water inlet. Move
			SUPPLY:		water ON/OFF CONTROL to ON position.
					Adjust WATER FLOW CONTROL lever to
					desired position. Drain watering system in
					cold weather to prevent freezing damage.
			BLADES:		Always follow blade manufacturer's
					recommendations for blade selection,
					speed and application.
					WARNING!
					NEVER exceed blade manufacturer's
					maximum rated RPM. See operator's manual
					for detailed blade mounting instructions.
			STARTING		Set CONTROL HANDLE to NEUTRAL position.
			ENGINE:		Set THROTTLE to IDLE. Turn start switch to
					ON position. Wait for glow plug indicator light
					to go out. Momentarily turn switch to start
					position; release switch as soon as engine
					starts. Allow engine to warm up for several
					minutes before increasing engine speed. Use
					approved diesel fuel only.
			STOPPING	Do not stop engine abruptly when hot! Reduce
			ENGINE:	THROTTLE to IDLE and allow engine to run 1

to 2 minutes before turning ignition switch off. Damage to engine may occur if not allowed to cool adequately.

	IGNITION SWITCH
ENGINE PRE-HEAT	OFF
GLOW PLUG
	ON
	ENGINE
	PRE-HEAT

	ENGINE WILL
START	NOT CRANK
	WHEN E-STOP
	BUTTON IS
	DEPRESSED

	BLADE SPEED
SYSTEMS STATUS	TACHOMETER
	37731 REV 04

	DEPTH STOP					WATER PUMP
TO ADJUST DEPTH LOOSEN POINTER KNOB, ROTATE POINTER TO						ON
DESIRED DEPTH AND RETIGHTEN POINTER KNOB TO LOCK IN CUTTING DEPTH.
						FORWARD
		10	11
				12		OFF
	9	260	280
				300
		240
8		220
	200
7 180					DEPTH INDICATOR
6	160				TO ADJUST CUT DEPTH INDICATOR	NEUTRAL
				LOWER SAW UNTIL BLADE CONTACTS
	140				SURFACE, ADJUST DIAL TO ZERO.
5	120				mm
		100		0	Inch
		80		20	0
	4			40
			60

31

2

REVERSE

LOWER

RAISE/LOWER

CONTROL

RAISE

PAGE 10 — CS4030 STOW SAW • PARTS MANUAL — REV. #0 (02/29/08)