3.Avoid eye and body damage. Arc rays and infrared radiation can injure eyes and burn skin. Wear ANSI approved arc shaded, impact safety full face shield and body protection. Do not allow viewing by visitors without proper eye and body protection.
4.Know proper arc welding practices. Read and understand the manufacturer’s instructions, and well as your employer’s safety practices for arc welding.
5.Connect only to a code approved power source. Connect only to a grounding power source conforming to the National Electrical Code and Local Codes.
6.Avoid fire and explosion. Remove flammable and explosive material from at least 35 feet from the welding arc to prevent welding sparks or molten metal from starting a fire. Keep a type ABC fire extinguisher within easy reach. Thoroughly clean the object being welded of any paint, grease, or other foreign material.
7.Avoid being burned. Always wear ANSI approved welding gear: leather gloves, leather apron, and shoes.
Unpacking
When unpacking, check to make sure the following parts are included.
MIG 200 Amp Welder
Wire Spool (1) not shown
220 VAC Power Cord
Torch Cable and Handle (2)
Ground Cable and Clamp (3)
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Assembly
1.Insert the Torch Cable (connection end) into the cable strain relief on the end of the unit. Refer to the photos on the next page.
2.Loosen and unlock the Wire Tension Control.
SKU 03664 | For technical questions, please call | Page 5 |