Subaru Robin Power Products PKV101 manual Maintenance, Stopping See Fig, Daily Inspection

GB

3.STOPPING (See Fig. 5)

(1)Set the speed control lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. (See Fig.5-q)

(2)Set the stop switch to the position “OFF”. (See Fig.5-w)

■Do not stop the engine suddenly when it is running at high speed.

(3)Pull the starter handle slowly and return the handle to its original position when resistance is felt. This operation is necessary to prevent outside moist air from intruding into the combustion chamber. (See Fig.5-e)

5.MAINTENANCE

(See Fig. 6)

1. DAILY INSPECTION

Before running the engine, check the following service items.

qLoose or broken bolts and nuts

wClean air cleaner element

eEnough clean engine oil

rLeakage of gasoline and engine oil

tEnough gasoline

ySafe surroundings

uCheck the priming water

iExcessive vibration, noise

2. PERIODIC INSPECTION

Periodic maintenance is vital to the safe and efficient operation of your pump.

Check the table below for periodic maintenance intervals. The below chart is based on the normal pump operation schedule.

CAUTION

Replace rubber pipes for fuel passage every two years. If fuel leakage is found, replace the pipe immediately.

3.INSPECTING THE SPARK PLUG (See Fig.7-q)

(1)Clean off carbon deposits on the spark plug electrode using a plug cleaner or wire brush.

(2)Check electrode gap. The gap should be 0.7 mm to 0.8 mm (0.03 inch.). Adjust the gap, if necessary, by carefully bending the side electrode.

Recommended Spark Plug : NGK CMR6A

Periodic Maintenance Schedule table

Maintenance items	Every 8 hours	Every 50 hours		Every 200 hours
	(Daily)	(Weekly)		(Monthly)
CLEAN PUMP SET AND CHECK BOLTS AND NUTS	● (Daily)
CHECK AND REFILL ENGINE OIL	● (Refill daily up to upper		level.)
CLEAN AIR CLEANER	●
CHANGE ENGINE OIL	(Intial 20 hours)	●
CLEAN SPARK PLUG		●
CLEAN FUEL FILTER		●
REMOVE THE PUMP CASING AND CLEAN				●
CLEAN AND ADJUST SPARK				●
PLUG AND ELECTRODES
CHECK AND ADJUST VALVE CLEARANCE (*Note 1)				●
CLEAN AND ADJUST CARBURETOR				●
CHECK SUCTION AND DELIVERY				●
CHECK VALVES
OVERHAUL ENGINE IF NECESSARY (*Note 1)				●

*Note: 1. As to the procedures for these items, please refer to the SERVICE MANUAL or consult your nearest Robin service dealer.

NOTE

Replace rubber hoses for passage every one year. If and when fuel leakage is found, replace hose at once.

6