Installing Right Angle Attachment

Only tighten flexible shaft nut finger tight. DO NOT use pliers or wrench.

CHANGING COLLET AND ACCESSORIES IN FLEXIBLE SHAFT

To change the collet or install an accessory in the flexible shaft, follow the same general procedure as for changing the collet and for installing accessories on the rotary tool. To lock the spindle, rotate the collet until the hole in the shaft is aligned with the hole in the flexible collar. Insert the L-key through the holes to lock the shaft.

4.Slide the collet nut over the drive shaft and thread it onto the motor shaft by turning the collet nut clockwise. Tighten the collet nut using the collet wrench.

5.Remove the right angle attachment adapter and collar from the right angle attachment by turning the collar counterclockwise.

6.Fasten the angle attachment adapter and collar to the tool by turning the right angle attachment adapter clockwise.

Only tighten by hand. DO NOT use pliers or wrench.

7.Insert the end of the drive shaft into the hole in the right angle attachment.

L-KEY

Do not attempt to loosen or tighten the collet without locking the shaft as noted above. Damage to the flexible shaft with result.

FOR MODELS 840168 AND 840169:

1.Remove spindle nut from the tool by turning it counterclockwise.

2.Remove the collet nut and the collet from the motor shaft.

3.Insert the short end of the drive shaft into the motor shaft until the stopper touched the shaft.

Rotate the right angle attachment collet nut as you push the right angle attachment onto the adapter until the square end of the drive shaft inserts into the matching square in the right angle attachment.

8.When drive shaft is fully engaged into the right angle attachment, lock the right angle attachment to the adapter by turning the adapter collar clockwise.

Only tighten by hand. DO NOT use pliers or wrench.

To change collet and accessories in the right angle attachment, use the same procedures as outlined for the flexible shaft.