Accessories

1	1. Screws

009951
Disconnect the connector by pulling them.
	1. Connector
	2. White
3	3. Black
3
1
2
009950

Loosen the four screws on crank cap and remove the crank cap cover.

To reassemble the tool, follow the disassembling procedure in reverse.

CAUTION:

•Do not tighten the crank cap excessively. It is made of resin and is subject to breakage.

1. Connector

2. White

3. Black

009954

Connect the connector firmly and then reinstall the handle.

CAUTION:

•Be careful not to damage the connector or lead

wires especially when installing the handle.

To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be

009952

1.Screwdriver

2.Crank cap cover

performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.

CAUTION:

• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other

Wipe out the old grease inside and replace with a fresh grease (60 g). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 60 g) can cause faulty hammering action or tool failure. Fill only with the specified amount of grease.

1	1. Grease
1
009953

CAUTION:

•Be careful not to damage the connector or lead wires especially when wiping out the old grease.

accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.

•Bull point (SDS-max)

•Cold chisel (SDS-max)

•Scaling chisel (SDS-max)

•Clay spade (SDS-max)

•Bit grease

•Safety goggles

•Hammer grease

•Plastic carrying case