Miller Electric INTEGRA 201/241 Maintenance and Troubleshooting, Routine Maintenance, Months

Page 14

SECTION 4 – MAINTENANCE AND TROUBLESHOOTING

4-1. Routine Maintenance

Y Disconnect power before maintaining.

3 Months

Replace unreadable labels.

Repair or replace cracked weld cable.

Clean and tighten weld terminals.

6 Months

Blow out or vacuum inside. during heavy service clean monthly.

OR

4-2. Circuit Breaker CB1

1 Circuit Breaker CB1

If CB1 opens, wire feeding stops.

2 Drive Roll Assembly

1

2

4-3. Unit Overload

If unit is used beyond capacity (excessive wire feed, shorted output, etc.), wire feeds but is not energized. Release gun trigger to reset this condition.

OM-188 414 Page 10

Image 14
Contents Description OM-188 414CProcesses From Miller to You Table of Contents Directives StandardsArc Welding Hazards Symbol UsageMarks a special safety message Electric Shock can killFlying Metal can injure eyes ARC Rays can burn eyes and skinWelding can cause fire or explosion Buildup of GAS can injure or killPrincipal Safety Standards EMF Information About PacemakersDuty Cycle and Overheating InstallationSpecifications Model Installing Gas SupplyVolt-Ampere Curves Electrical Service Guide Installing Drive Roll and Wire Inlet GuideInstalling Wire Spool and Adjusting Hub Tension Selecting a Location and Connecting Input Power Installing Work ClampOperation ControlsCircuit Breaker CB1 Maintenance and TroubleshootingRoutine Maintenance Unit OverloadTroubleshooting Trouble RemedyElectrical Diagram IntegraDia Code Dwg Parts ListCommon Parts Assembly Code DwgDia Qty Code Dwg 201 Main AssemblyDia Effective January 1 Owner’s Record Miller Electric Mfg. Co